Crane hill engineering power press PP2 s/n 50A1467/1

Report expires: 19/11/2026

Report of thorough examination of lifting equipment

Last Updated	Date of report	Report number
Nov 19, 2025	Nov 19, 2025	crane-hill-engineering-power-press-pp2-s-n-50a1467-1

Name and address of employer				Address of the premesis
Crane hill engineering Ltd Harvey reeves road NN5 5JR				Crane hill engineering Ltd Harvey reeves road NN5 5 JR

Description of the equipment	Safe working load	Date of exam	Date of manufacture	Date of last examination
Mechanical power press PP2 R4A C frame fixed	Max 50tons none lifting	Nov 19, 2025	Unknown	Unknown
Defects See below

Is this the first examination after installation?	Has the equipment been installed correctly?
no	yes

Was the examination carried out?	In accordance of the examination scheme?	In exceptional circumstances?
In an interval of 12 months	yes	no

Identification of any part found to have a defect which is or could become a danger to persons and a description of this defect:
Other defects: Toolsetters disconnect link roller arm taper pin worn - replace pin and secure arm Operating foot pedal to be shrouded to prevent accidental operation Stroke scotch arm taper pin worn - replace pin and secure arm Advise bolt press fully to floor Front guard interlock cup loose and cracked - repair/replace and secure Front guard bars bent/misaligned exposing gaps - straighten bars to close all gaps Observations: Play in Pitman Ball; 2.5mm, Play in Pitman Screw: 0mm, Play in Stroke Bearing: 0mm

Identification of any part found to have a defect which is or could become a danger to persons and a description of this defect:

Other defects: Toolsetters disconnect link roller arm taper pin worn - replace pin and secure arm

Operating foot pedal to be shrouded to prevent accidental operation

Stroke scotch arm taper pin worn - replace pin and secure arm

Advise bolt press fully to floor

Front guard interlock cup loose and cracked - repair/replace and secure

Front guard bars bent/misaligned exposing gaps - straighten bars to close all gaps

Observations: Play in Pitman Ball; 2.5mm, Play in Pitman Screw: 0mm, Play in Stroke Bearing: 0mm

Particulars of any test carried out as part of the examination?
Full test carried out to PUWER requirements

Is the above a defect which is immediate danger to persons	no
Is the above a defect which is not yet but could become an immediate danger to persons	no

Is this equipment safe to operate?	Yes

Name of person authenticating this report:	Andrew Sands BAGMA Approved Thorough Examiner BAGMA ID: 210011893 The Loler Man - NN15 6TP